Skip to content
Packs of 2, 3 or 6 jars60-day money-back guaranteeSecure checkout
Gelatox™
Home/Blog/How to Build a Garden Gate Latch From Scrap Wood
Lifestyle

How to Build a Garden Gate Latch From Scrap Wood

By Gelatox Editorial TeamPublished October 21, 2026Updated November 17, 20264 min read
Quick answer

To build a garden gate latch from scrap wood, cut a 10-inch bar from a 1 by 2, drill a pivot hole near one end, screw it to the gate so it swings freely, fasten a notched catch block to the post, and add a string through a hole in the gate so the bar lifts from the other side. It takes about an hour.

Key takeaways
  • A pivoting bar and a catch block make a complete latch.
  • A loose pivot screw is the secret to easy swing.
  • A string loop lets you lift the bar from both sides.
  • Build it in one easy hour and keep your tools together.

Understand the parts

A wooden bar latch has only three pieces, and every one of them can come from your scrap bin. The first is the bar, a length of 1 by 2 about 10 inches long. The second is the catch, a small block with a notch cut in it. The third is a bit of cord. When the gate closes, the bar drops into the catch and holds it shut; lift the bar and the gate swings open.

This design has been used on barn doors and garden gates for generations because it has nothing to rust, nothing to break, and nothing you can't repair with a screwdriver.

  • One 1 by 2 bar, about 10 inches
  • One catch block, about 3 inches square
  • Two 2-inch exterior screws and a washer
  • A few feet of outdoor cord

Cut and drill the bar

Choose a straight piece of cedar, oak or any dense scrap that is free of cracks. Cut it to length with a handsaw and round the ends with sandpaper. About an inch from one end, drill a hole slightly larger than your pivot screw. This is the pivot, and the extra width is what lets the bar swing freely.

Drill a second, smaller hole about an inch from the other end for the pull cord. Thread the cord through, tie a knot on the underside, and leave a tail long enough to reach the gate edge.

Ready to start your routine?

Gelatox: a daily gummy routine and a 60-day money-back guarantee.

Order Gelatox Now

Make the catch block

Take the 3-inch block and cut a notch into one face that is the same width as the bar and about half an inch deep. A few passes with a handsaw and a chisel are enough. Test the fit by dropping the bar in; it should seat with a slight clack and not wobble from side to side.

Sand the notch lightly so the bar slides in and out without catching. A little candle wax rubbed on the surfaces keeps the movement easy through wet seasons.

Mount it on the gate and post

Hold the gate closed and mark the position of the bar at a comfortable height, roughly 36 inches from the ground. Fasten the pivot end to the gate with a screw and washer, leaving it a half turn loose so the bar swings. Mark where the free end lands on the post, then screw the catch block there with two exterior screws, with its notch facing up.

Drill a small hole through the gate, just below the bar, and pass the cord through so it hangs on the outside. Now you can open the latch from either side with a simple pull. Test it several times, then adjust the catch block up or down until the bar settles in cleanly.

For a general reference on common materials, PubChem is a free public database.

Keep your projects on a rhythm

Small fix-it builds work well in a routine, with one project per weekend and a standard morning to start. Lay out the tools in the same spot each time and projects like this one end up taking less time than expected.

Gelatox™ is a daily chewable gummy dietary supplement for adults, and the brand's directions are two gummies daily, ideally about 30 minutes before breakfast or lunch, with a full glass of water. That pre-breakfast cue is an easy anchor for the rest of your morning. See what Gelatox is, check the pack options, or browse the blog for more ideas.

Related guides

FAQ

Quick answers

Cedar, oak and other dense woods resist weather best, but any clean, dry scrap will serve for a first latch. Seal it with exterior oil or outdoor paint to keep it from soaking up water. Use exterior-rated screws so the hardware does not rust and stain the wood over time.

Usually the notch is a little too tight, or the pivot screw is snug. Back the pivot screw off by a quarter turn so the bar swings freely, then sand the sides of the notch lightly. Rubbing a bit of candle wax on both surfaces keeps the motion easy in damp weather.

It is one small step in the morning. The brand's directions for Gelatox are two gummies daily, ideally about 30 minutes before breakfast or lunch, with a full glass of water, and you should follow the directions printed on the jar label. Each jar holds 60 gummies. More answers are in the site FAQ.
Ready when you are

Start your Gelatox routine today

A daily gummy jar, a full label printed on it and a 60-day money-back guarantee. Choose a 2-, 3- or 6-jar pack on the secure order page.

Order Gelatox NowBacked by a 60-day money-back guarantee · Secure checkout
Six jars of Gelatox daily gummies
Gelatox™ gummies60-day money-back guarantee
Order Now