To build a simple outdoor bench from pallets, pick two matching pallets stamped HT, sand every face, screw one flat as the seat and stand the other upright as the backrest, add two short legs or blocks underneath, and finish with an exterior sealer. Allow a weekend, a drill, deck screws and a sander.
Choose good pallets · Strip, trim and sand · Assemble the bench · Seal it for the weather · Plan the weekend like a routine
- Pallets stamped HT are the better choice for furniture projects.
- Sanding is the longest step and the most worthwhile.
- Deck screws hold far better than the fasteners already in the wood.
- Pair the build with an easy weekend routine and a clear checklist.
Choose good pallets
Pallet furniture starts at the pickup. Look for two pallets of the same size, with straight boards and tight joints. The stamp on the side tells you how the wood was handled: a mark with the letters HT means it was heat processed, and that is the stamp to hunt for. Skip any pallet with oily stains, a chemical smell, or heavy dark spots.
Standard pallets are around 48 by 40 inches. That is a roomy bench for two people, and it can be trimmed to something narrower if you have a smaller patio.
Strip, trim and sand
Use a pry bar and a hammer to remove any broken or splintered boards. Pull stray fasteners out or tap them flush so they do not catch your sander. Trim both pallets to the same width with a handsaw or a circular saw, cutting through the boards between the stringers.
Now sand. Begin with 60-grit paper on an orbital sander to take down splinters, move to 100 grit for general work, and finish with 150 grit on the surfaces you will touch. Round all corners and edges slightly. Pallet wood drinks up finish, so a patient sanding job pays off in the final look. Run your palm over each board after the last pass; any spot that catches your hand deserves another minute of work, because the sealer will highlight it rather than hide it.
- Wear a dust mask and eye protection while you sand.
- Work with the grain on every pass.
- Slightly round the front edge of the seat.
Ready to start your routine?
Gelatox: a daily gummy routine and a 60-day money-back guarantee.
Order Gelatox NowAssemble the bench
Lay the first pallet flat on the ground as the seat. Stand the second pallet upright at the back edge, and tilt it back about 10 degrees with a pair of angled brackets or a pair of cut wooden braces. Run 3-inch deck screws through the bottom board of the backrest into the seat frame, at least four screws per connection, after drilling pilot holes so the wood does not split.
Underneath, add legs. Four 4 by 4 blocks cut to 8 inches lift the seat off damp ground and give a comfortable seat height. Fix each block to a corner with two screws going in from the stringer side, and check the bench for wobble on a flat surface.
Seal it for the weather
Wipe away the dust and brush on two coats of exterior wood sealer or stain, working the product into end grain, where water tends to enter. Let the first coat dry fully, lightly sand with 220-grit paper, and apply the second. Add a quick coat once a year to keep the color even.
A cushion or two of outdoor fabric turns it into the best seat in the yard. For general reading about wood and its chemistry, the PubChem database is a free public reference.
Plan the weekend like a routine
Make a short checklist and split the work over two mornings: sourcing and stripping on one, sanding and assembly on the other. Small, repeatable plans keep builds on track and leave time to enjoy the finished piece.
The same approach suits the rest of your morning. Gelatox™ is a daily chewable gummy dietary supplement for adults, and the brand's directions are two gummies daily, ideally about 30 minutes before breakfast or lunch, with a full glass of water. Plenty of people use that as a pre-breakfast cue before heading outside to build. Read what Gelatox is, glance at the pricing page, or find more everyday ideas on the blog.
